2
HermanMiller for Canvas Channel 90
°
Connector Installation Instructions
Replacement Instructions
1BKRBR rev B
For 22” High Products when used with Architectural Foot:
Washer
2.2 Assemble Connector Tube to frames at slot location as shown below
with Screws and Washers. Tighten screws.
Important: Torque screws to 200 in-lbs.
Step 3
3.1 Before cladding has been installed, install Light Seal in inside corners.
3.2 With the one-inch cut-out in the light seal facing up, rest the top set of
arms on the top connector block.
Light Seal
For 29” High Products
Washer
Use second from
bottom slot to attach
4.1 Place one arm so that the curved portion sits well on the
bend of the frame.
4.2 Push the other arm in, so that it snaps. Repeat for the entire
length.
4.3 Cut light seal off even with bottom of frame.
Light Seal
Step 4
