9/16” Socket
9/16”
Wrench
Torque
Wrench
Ratchet
Safety Glass
Tools Required
Parts Included
HermanMiller
Canvas Channel
90° Connector
Installation and Disassembly for
Recycling Instructions
How to assemble and reassemble your
90° Connector
Step 1
Assembly Instructions
Step 2
Connector Tube(2)
Light Seal
3/8-16 Hex Head
Cap Screw
FZ121.2(4)
FZ121.3(6)
FZ121.4(8)
FZ121.2(1)
FZ121.3(2)
FZ121.4(4)
Hardware Pack
Washer
Notice:
Do not tighten screws until at least 2 frames are completely connected.
Notice:
Make certain that fasteners are torqued to the specified values.
1.1 Align 2, 3 or 4 wall frames.
1.2 Connect frames to Top Connector Tube if using the FZ121 product using
Screws and Washers at top hole location. For 3 way connection make sure
Top Connector Tube open side faces outward. Do not tighten screws.
For 22” High Products when used with Structural Foot:
Hole
Frame
Connector Tube
Open
Side
Slot
Washer
Use the bottom slot to attach
2.1 Assemble Connector Tube to frames at slot location as shown below
with Screws and Washers. Tighten screws. Continue to Step 3.
Important: Torque screws to 200 in-lbs. Start with top connector
tube, then bottom.
1
HermanMiller for Canvas Channel 90
°
Connector Installation Instructions
Replacement Instructions
1BKRBR rev B
