CLEANING INSTRUCTIONS
User should perform cleaning procedure on a regular basis (See Figure 2).
CAUTION
Clean crusher immediately if piston fails to retract.
Failure to clean may damage crusher.
CLEANING PROCEDURE
A. Empty crush chamber and disconnect air.
B. Remove cleanout panel and clean sludge from drain pan.
C. Replace cleanout panel and reconnect
air supply.
D. Cycle crusher and allow piston to
fully extend.
E. Insert retaining pin Into hole to
lock piston in place.
F. Disconnect air supply and fully
exhaust air bag.
G. Hold waste oil reservoir to prevent
spill and remove mounting bolts.
H. Remove waste oil reservoir and
dispose of contents according to
applicable environmental
regulations.
I. Remove cleanout plug from
waste oil reservoir.
J. Scrape sludge from bottom of
waste oil reservoir.
K. Replace clean out plug and install
waste oil reservoir.
L. Reconnect air supply and cycle
machine to remove pin.
Clean out
panel
Drain pan
Waste oil
reservoir
Retaining pin
Clean out plug
Reservoir
mounting bolts
Figure 2
WARNING
Disconnect Air
Supply Before
Cleaning
Page 6 of 8