HERKULES G507, Руководство пользователя

Страница: 8 / 12

Preparing the equipment to be washed
1) Remove paint cup from the paint gun. Allow the air line to remain
attached to the paint gun, or connect the air line added to the side
of the unit.
2) Drain any unused paint into a separate container.
3) Remove all gauges and regulators from painting equipment.
Cleaning equipment
1) Place the paint channel of the paint gun under the cleaning nozzle.
Squeeze the trigger of the paint gun while pressing the paint gun
up against the nozzle to activate the pump. Allow the pump to run
for 10-15 seconds.
Note: Position the spray gun so that the flow of water/solvent exiting
the paint gun is contained within the Gun Washer cabinet.
2) Clean the air cap of the paint gun by rubbing it on the panel
mounted brush.
3) Dry the paint gun using the air blow gun on the side of the unit.
4) Dispose of all paint waste according to local, state
and federal regulations.
Troubleshooting
Pump turns on but wash water
1 Make sure wash bucket is not empty.
does not flow.
2 Make sure the pick up tube is completely submerged in water.
3 Check all fluid connections to ensure that there are no leaks.
Pump does not turn on. 1 Make sure the air line is properly connected with at least 75 psi.
Air pressure is regulated at 75 psi.
2 Check all air connections to ensure that there are no leaks.
Possible Solution Problem
Operation
Cleaning
Nozzle
Air Blow Gun
Page 8 of 12