L
IMITED
W
ARRANTY
The SC-190 Hot Knife Styrofoam Cutter is warranted to be free of defects in material and workmanship under
normal use for a period of 60 days from the date of purchase.
Liability is limited to repair or replacement of material found defective, free of charge F.O.B. St. Louis, MO.
Unauthorized repairs, modifications, or replacements will not be subject to factory warranty.
Except as contrary to State or Federal laws, Universal Sewing Supply shall not be liable to any party for
loss, injury or damage, whether direct, indirect or consequential arising out of or the inability to use the
equipment or other products made, repaired or sold by Universal Sewing Supply or any of its distributors.
B
LADE
I
NSTALLATION
IMPORTANT: Always unplug the power cord of the SC-190 Hot-Knife Cutter before installing or removing the blades.
Allow sufficient cooling time for blades, blade holders and mounting screws before handling.
Straight Blade:
1. Loosen the screws on the blade holders with the wrench.
2. Slide the blade under the square pressure plates until snug.
3. Securely tighten screws to assure the proper electrical connection. Do not over-tighten.
4. Once the blade is firmly in place, plug your SC-190 Hot-Knife Cutter unit into a standard 110 volt AC power
supply.
5. The temperature control knob has 16 click setting stops that correspond to the graduated ridges on the
surface. The smaller the ridge the lower the power setting.
S
PECIFICATIONS
M
AINTENANCE
Input: 110 Volts AC
Output: 190 Watts
Weight: 10 Ounces
Length: 10¼ Inches
Width: 2 Inches
Temperature: 600°+
Regular use of the SC-190 Hot-Knife Synthetic
Materials Cutter may result in material buildup on
blades and the brass holders. This excess material
interferes with the proper heating and impairs the
performance of the blades. The blade holders and
blades can be thoroughly cleaned with a wire brush.
B
LADES &
B
LADE
A
CCESSORIES
Our stainless steel
BLADE PLIERS
make it easy to form our 12” Flat
Blade (Part# 7729) for any custom
cut or pattern.
Part # 7740
Flat Blade 12 Inches (200 mm)
Part # 7729
8 Inches
(200 mm)
Part # 7724
6 Inches
(150 mm)
Part # 7723
4 Inches
(100 mm)
Part # 7722
3 Inches
(75 mm)
Part # 7721
Size and bend blade to the shape you desire using our stainless steel blade pliers (Part# 7740)
BLADE HOLDER
for flat blade (Part#7729).
Size and shape blade to your desired cut.
Part # 7728
