Hercules LT0892, Инструкция по эксплуатации

Страница: 7 / 17

lever and the regulating screw (140M) on the crank link (139M) to
make the crank link be dragged (now the lowering valve is open,
but hydraulic valve is close), while the forks in the state of neither
lower nor lift position.
5.7.3 Adjustment of lifting position
1) Place the handle bar in lifting position .
2) Pump the control lever, the crank link (139M) shall not be dragged
(now the lowering valve and hydraulic valve is close), the forks in
the working state of lifting.
3) If the forks do not lift, regulate the nut (H1104) and the regulating
screw (140M), until satisfy the needs of normal position and lifting
position simultaneously.
5.7.4 Adjustment of lowering position
1) Pull the handle bar in lowering position
.
2) The crank link (139M) shall be dragged, and make the lowering
valve and hydraulic valve open completely, the forks in the
lowering state.
3) If the forks do not lower, regulate the nut (H1104) and the
regulating screw (140M), until satisfy the needs of three state
positions simultaneously.
5.8 Forks height adjustment
Two rollers (F1207) in the upper carriage are mounted on eccentric
axle (F5922), turn the eccentric axle, and adjust the tilting angle of
the carriage so that they can be adjusted.
Adjustments:
1) Loosen the setting screw (F5919, each one on the left and right.).
2) Lock the hexagon point of the eccentric axle (F5922) with a wrench,
the eccentric axle can now be turned to give the necessary
adjustment.
3) Turn the eccentric axle back can make the fork tilt to the front (that
is the front is low and the back is high), Turn the eccentric axle front
can make the fork tilt to the back (that is the front is high and the
6