Page 7
For technical questions, please call 1-888-866-5797.
Item 56564
OPERATION
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Make sure that the Trigger is in the off-position and
remove the Battery Pack before performing any
procedure in this section.
Attaching / Removing Accessories
CAUTION!
Only use 1/4" hex shank bits. Verify
bit fits the Chuck precisely before use.
1. Pull Collar forward and insert an appropriate
accessory (sold separately) into the hex drive
Chuck. Pull on bit to ensure it is secure.
2. To remove, pull Collar forward, remove bit
from Chuck and then release Collar.
Collar
Attaching Belt Clip
Attach Belt Clip to Handle using supplied
Screw. Clip may be attached to either side.
Screw
Belt Clip
Setting Torque
1. Set torque by rotating Torque Selector.
Note:
The proper torque setting depends
on type and size of fastener being driven, as
well as type of material being driven into.
2. Adjust the torque setting low enough to allow
a safety margin. Use a very low torque setting
when first driving small screws into soft materials.
Then adjust the setting as the proper force required
is determined. If a pilot hole has been drilled into
the material, a lower torque setting will be required.
Speed Selection
Adjust Speed Selector to proper setting:
• Low Speed: Select 1
• High Speed: Select 2
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
3. There must not be objects, such as utility lines,
nearby that will present a hazard while working.