Page 8
For technical questions, please call 1-888-866-5797.
59380
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
Tool Changing
Bit Installation
CAUTION!
Only use impact rated accessories
with this tool. Other accessories may
shatter, chip, or crack during operation.
Connect an appropriate, impact rated square
drive socket (sold separately) onto the Anvil.
Attaching Belt Clip
Attach Belt Clip to Handle using supplied
Screw. Clip may be attached to either side.
Screw
Belt Clip
Setting and Testing
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Make sure that the Trigger is in the off-position
and remove its Battery Pack before
performing any procedure in this section.
1. Ensure bit is correctly installed in Impact Wrench.
2. Make sure that the Trigger is in the off-position,
then insert a fully charged Battery Pack
into the base of the Impact Wrench, making
sure that it clicks into place securely.
3. Press the Trigger and test run tool
for at least 30 seconds.
4. If abnormal noise or vibration occurs, have
the problem corrected before further use.
5. Release Trigger and disconnect Battery Pack.
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
3. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
