Page 6
For technical questions, please call 1-888-866-5797.
Item 57319
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
Accessory Installation
1. Flip the Release Lever forward to the open position
in order to remove the Flange Assembly.
Flange
Assembly
Release
Lever
Saw
Blade
2. Install the desired accessory, Saw Blade shown,
by inserting onto the Shaft fitting pins.
3. Reattach the Flange Assembly and hold in place
momentarily to keep the accessory secure.
Note:
Accessories included are wood blade,
saw blade, sanding pad, and sandpaper.
Note:
Accessories may be mounted at angles
up to 90° left or right of straight ahead.
Note:
The Saw Blade should only be
used in the straight ahead position.
CAUTION!
When attaching the Saw Blade,
orient the accessory so that the blade faces
AWAY from the handle to avoid injury.
4. Flip the Release Lever back to original
position to secure accessory.
5. After securing, the attachment should not move
on the Spindle. If it can move with the power off,
reattach it, making sure that the holes on the
attachment line up with the fitting pins on the Shaft.
Note:
For sanding, first attach the Sanding Pad to the
tool, then align a sheet of Sandpaper over the pad and
press into place. Once a Sandpaper corner becomes
worn, turn it 120° or replace the sheet with a new one.
Workpiece and Work Area Set Up
1. Designate
a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
3. There must not be hazardous objects, such
as utility lines or foreign objects, nearby that
will present a hazard while working.
4. You must use personal safety equipment including,
but not limited to, ANSI-approved eye and hearing
protection, as well as heavy-duty work gloves.
General Operation
To prevent serious injury: Grip the
tool firmly in both hands.
1. Make sure that the Power Switch is in the
off-position, then plug in the tool.
2. Hold the Tool with both hands and slide
the Power Switch forward to activate.
3. Adjust the speed of the tool using the Speed
Control Dial. There are six speed settings from 1
(slowest) to 6 (fastest). Determine the optimum
speed by testing on a scrap piece of material.
4. Do not allow contact between Sandpaper
or Blade and workpiece until the tool is
running at the intended speed.
5. Avoid contact with foreign objects such as metal
screws and nails when sanding, scraping, or cutting.
6. Do not apply excessive pressure on the
Tool. Allow the Tool to do the work.
7. When finished, slide the Power Switch to OFF. Allow
the tool to stop completely before setting it down.
8. To prevent accidents, turn off the tool and
unplug it after use. Clean, then store the
tool indoors out of children’s reach.
MAINTENANCE AND SERVICING
Procedures not specifically explained
in this manual must be performed
only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Make sure that the Switch is locked and
Battery
Pack is removed before performing any procedure in
this section.
