Page 6
For technical questions, please call 1-888-866-5797.
Items 63381 63382
Mode Selection (Model HC92K1 only)
Rotate Mode Selector so arrow is
pointing to desired mode.
Drilling
Drilling in wood and metal.
Driving
Driving screws, bolts and installing nuts.
Hammer Drilling
Drilling in masonry.
Setting Torque when Driving
1. Set Mode to Driving (Model HC92K1 only).
2. Set torque by rotating Torque Selector.
Note:
The proper torque setting depends
on type and size of fastener being driven, as
well as type of material being driven into.
3. Adjust the torque setting low enough to allow
a safety margin. Use a very low torque setting
when first driving small screws into soft materials.
Then adjust the setting as the proper force required
is determined.
If a pilot hole has been drilled into the material,
a lower torque setting will be required.
Speed Selection
Adjust Speed Selector to proper setting:
• Low Speed: Select 1
• High Speed: Select 2
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
3. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
General Operation
1. Lock Trigger, then insert a fully charged Battery
Pack, making sure that it clicks into place securely.
2. Set Direction Switch:
Forward:
Push Switch in on right side
(arrow pointing forward) for clockwise rotation.
Reverse:
Push Switch in on left
side (arrow pointing backward) for
counter-clockwise rotation.
Trigger Lock:
Push Switch to the
center to lock the Trigger.
CAUTION! Set Control Switch to center
Trigger Lock position during set up, when
changing bits or when tool is idle.
Push
for
Forward
Push
for
Reverse
Push to Center to
LOCK TRIGGER
3. Install bit, select Mode (Model HC92K1 only),
Torque (when driving), Speed and Direction.
NOTICE: Do not change direction of rotation
while Chuck is rotating.
Wait until Chuck has come
to a complete stop before changing direction.
4. Press Trigger. The Work Light will turn on
when Trigger is pressed and turn off a few
seconds after Trigger is released.
5. When inserting or removing a screw or bolt, use
slight pressure at first to keep the bit in the head
of the screw or bolt and cause the screw or bolt
to thread into or unthread from the material.
6. When drilling a hole, let the tool do the work,
using only enough pressure to follow the
drill as it cuts the hole in the material.
7. When drilling a hard, smooth surface, use a center
punch (not included) to mark the desired hole.
8. When finished using the Drill, release Trigger
and center Direction Switch to lock Trigger.
