Page 5
For technical questions, please call 1-888-866-5797.
Items 56534 56533
Specifications
Model HC91B
Model HC92B
Battery Pack
Hercules 20V Li-Ion 2.5Ah Item 56562 and
5.0Ah Item 56560 (both sold separately)
Battery Charger
Hercules 20V/12V Multi-Voltage Charger
Item 56559 (sold separately)
No Load
Speed RPM
0-600/0-2,000
BPM
–
0-10,200/0-34,000
Max Torque
576 in-lb
Chuck Size
1/2"
Steel Capacity
1/2"
Wood Capacity
1-1/2"
Masonry
Capacity
–
1/2"
Warning Symbols and Definitions
This is the safety alert symbol. It is used to
alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol to
avoid possible injury or death.
Indicates a hazardous
situation which, if not
avoided, will result in death or serious injury.
Indicates a hazardous
situation which, if not
avoided, could result in death or serious injury.
Indicates a hazardous
situation which, if not
avoided, could result in minor or moderate injury.
Addresses practices not
related to personal injury.
Functional Description
1. Jaws
2. Chuck
3. Torque Selector
4. Mode Selector
(Model HC92B only)
5. Speed Selector
6. Direction Switch
7. Trigger
8. Work Light
9. Battery Pack (sold separately)
8
1
3
6
4
5
7
2
9
OPERATION
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Make sure that the Trigger is locked and
Battery
Pack is removed before performing any procedure
in this section.
Battery Charging
Charge battery after unpacking and before
using this tool. Follow instructions included
with battery charger (sold separately).
Bit Installation
CAUTION!
Wear heavy-duty work gloves
to provide protection when inserting and
removing bits. Bits become very hot during
use. Do not remove bit until it has cooled.
NOTICE:
Use sharp bits. Dull, bent, or damaged
bits will cause stress on the drill and/or break.
1. Rotate Chuck counterclockwise until Jaws
are opened enough for bit to fit.
2. Use a bit designed for workpiece type. Place
desired drill, screwdriver, bolt or nut bit into Jaws.
Note:
In addition to single or double-ended
bits, adapters with Hexal shafts with matching
socket heads can also be used.
3. Rotate Chuck clockwise until bit is held
securely in place, centered between Jaws.
Attaching Belt Clip
Attach Belt Clip to Handle using supplied
Screw. Clip may be attached to either side.
Screw
Belt Clip
