Page 9
For technical questions, please call 1-888-866-5797.
Item 56815
General Instructions for Use
1. Make sure that the Trigger is in the off-position,
then attach the Battery Pack by sliding it
into the Battery Receptacle until it clicks
in place. Remove the Battery by pressing
its Latch and pulling the battery out.
2. Attach Accessory Nozzle, if desired.
3. To start the Heat Gun, release the Trigger Lock
button by pressing it to the left or right and
then squeeze the Trigger. The Trigger must
be squeezed for the Heat Gun to operate.
Releasing
Trigger Lock
Trigger
4. Squeeze the Trigger for one minute, allowing
the Heat Gun’s output to build up to the
desired heat level. The LED Indicator will
light when the Heat Gun is operating.
WARNING! To prevent serious injury
do not leave the Heat Gun unattended
while pointed at surfaces or objects.
CAUTION! Do not touch work area with
the Heat Gun; it could scorch or ignite.
CAUTON! Do not block Air Vents when the Heat
Gun is in use; it could cause the tool to overheat
.
5. Before moving or storing the Heat Gun, or
changing accessory nozzles, release Trigger
and allow time for the tool to cool down on
an insulated, non-flammable surface.
a. After releasing the Trigger, the internal fan will
continue to run, cooling down the tool. The
LED Indicator will flash for about 6 seconds
before the tool is automatically turned off.
b. When the tool is completely off, the
LED Indicator will extinguish.
CAUTION! After use, do not touch
Nozzle until it has had time to cool.
CAUTION! Do not leave work area until Heat Gun
has cooled. Be alert for indications of concealed fire.
6. After use, allow time for the Heat Gun to cool
then disconnect the Battery Pack. Disconnect
Accessory Nozzle. Clean, then store the
Heat Gun indoors out of children’s reach.
