Page 3
For technical questions, please call 1-888-866-5797.
Item 58919
Specifications
Vacuum Attachment 1-1/2" O.D., 1-1/4" I.D.
Wheel Capacity
7"
Setup - Before Use
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Turn the Power Switch of the appliance off and
unplug the appliance from its electrical outlet
before performing any procedure in this section.
Note:
For additional information regarding the
parts listed in the following pages, refer to the
Parts List near the end of this manual.
1. Carefully inspect condition of Dust Shroud
parts before use. Check for damaged parts.
Do not use and replace any damaged part.
2. Use only identical replacement parts. Use
of any other part will void warranty.
3. Use the right part for the job. Do not modify
the Dust Shroud or use its parts for a purpose
for which they were not intended.
4. Do not place Vacuum Hose in walkways
or in any trafficked location. Set up Dust
Shroud in a location where people or
vehicles will not trip or run over hose.
5. Keep hose away from sharp
objects and excessive heat.
OPERATION
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
Attaching Tool to Dust Shroud
1. Remove the tool’s battery pack,
guard, and any accessories.
2. Turn tool upside down and place on even surface.
3. Install appropriate size ring (15) onto tool.
4. Open Clamp Handle (10) and loosen Clamp Nut
(13) to allow enough room for tool to fit securely
5. Turn Shroud upside down and place over tool’s
spindle, making sure the tabs on Shroud align
with corresponding slots on tool. See below.
Tabs
6. Turn Shroud and tool upright and
rotate Shroud to desired position.
7. Make sure Shroud is centered on spindle. Close
Clamp Handle (10), then retighten Clamp Nut (13).
8. Attach desired accessory to tool according
to instructions in the tool’s manual.
9. Test fit the accessory to the tool. The grinding
surface of the accessory should be close
to flush with the ends of the brush.
10. If the accessory is not close to flush, a spacer
(16) can be added between accessory
and spindle to improve the distance.
11. Insert Vacuum Hose (18) into dust port.
