Hercules FUTURA COMPACT 10, Перевод оригинальной инструкции по эксплуатации

Страница: 38 / 128

MY21H01 - 22_1.0_30.08.2020
38
Assembly
2 Push in the quick release until you can hear a
click. Make sure that the flange is extended.
Figure 24: Pushing the quick release in
3 Adjust tensioning with half-open clamping
lever until the flange reaches the fork end.
Figure 25: Adjusting the clamping
4 Fully close the quick release. Check that the
quick release is firmly in place and adjust it on
the flange if necessary.
 The lever is secured.
Figure 26: Closing the quick release
5.4.2 Checking the stem and handlebars
5.4.2.1 Checking the connections
1 Stand in front of the pedelec to check whether
the handlebars, stem and fork steerer are
firmly attached to one another. Clamp the front
wheel between your legs. Grasp the handlebar
grips.
2 Try to twist the handlebars towards the front
wheel.
 The stem must not move or twist.
5.4.2.2 Firm hold
1 Place your entire body weight on the
handlebars with the quick release lever closed
to check that the stem is firmly in place.
 The handlebars shaft must not move
downwards in the fork steerer.
2 If the handlebars shaft should move in the fork
steerer, increase the quick release lever
tensioning. To do so, turn the knurled nut
slightly in a clockwise direction with the quick
release lever open.
3 Close the lever and check the stem is firmly in
position.
5.4.2.3 Checking the headset backlash
1 To check the handlebar headset backlash,
close the quick release lever on the stem.
2 Place the fingers of one hand on the upper
headset cup. Pull the front wheel brake with the
other hand and try to push the pedelec
backwards and forwards.
3 The headset cup halves must not move
towards one another while you are doing this.
Note that there may be noticeable backlash
due to worn-out bearing bushes or brake lining
backlash in suspension forks and disc brakes.
4 If there is headset backlash in the steering
headset, you must adjust it as soon as
possible; otherwise, the headset will become
damaged. You must make the adjustment as
described in the stem manual.