Heras HGD230, Руководство пользователя

Страница: 49 / 146

EN – Translation of the original user manual - 2.1 | 2019 49
6 INSTALLATION
This chapter is about commissioning the HMD230.
6.1 ELECTRICAL CONNECTION
In principle, and for safety reasons, the electrical system must be
connected by a qualified electrical engineer. Work on the motor drive is only
permitted if the power supply is fully interrupted. To fully interrupt the power
supply, an isolator switch or mains plug must be installed and used. The isolator
switch or mains plug must be within easy reach.
Observe the instructions in the chapter Safety. Avoid parallel signal and energy
leads and cables where possible. The dimensions of all leads and cables must be
adjusted to the power consumption.
The Cable glands must be treated this way that the protection against water and
foreign objects penetrating is still compliant with the IP classification after
introducing the leads and cables.
6.1.1 Connecting the supply voltage and the drive motor
When connecting the motors, follow the wiring diagrams as supplied by the motor
manufacturer.
The HMD230 has been designed for 230V
AC
single-phase input voltage:
it generates a rotary field of 3 x 230V
AC
.
Connect the motor drive as shown in the illustrations below:
Illustration 24: Electrical connection