Heras HGD230, Руководство пользователя

Страница: 16 / 146

EN – Translation of the original user manual - 2.1 | 2019 16
• In certain circumstances, the sun can temporarily distort the gate. When
closing the gate, the leaf is guided to its neutral position. When opening
the gate, the leaf will move around somewhat. This has no adverse
consequences for the construction.
•
Climbing the gate is strictly forbidden as people climbing the gate could
be hurt if the gate is started unexpectedly.
•
Do not stick any objects through, over or under the gate which might
block the gate.
•
Do not place any obstacles in the opening.
•
Always lock the drive unit cabinet during use.
2.7 SAFETY DURING INSTALLATION, MAINTENANCE AND
DISASSEMBLY
•
When work is carried out or while cleaning the gate, the power supply to
the system must be switched off and it must be ensured that it cannot be
switched on unexpectedly.
•
Use the necessary personal safety equipment.
•
The gate is driven by means of a gear wheel. This is located under the
beam and it is partly screened off by the drive unit cabinet. Beware of
moving parts when carrying out maintenance under the gate at the drive
unit cabinet.
• To move the gate manually, first switch the automatic fuse in the drive
unit cabinet to “off” and make sure it cannot be switched on again (e.g.
by locking the cabinet).
•
The EN 13241 and EN 12453 standards must be taken into consideration
during installation. To achieve a good safety level, both the above
standards and the national regulations must be taken into account in non-
EC countries.
The Delta, uGate and iGate have highly tensioned cables fitted in
the bottom rail. If these cables are damaged, they can snap with
great force. This can lead to serious injury. Therefore, it is prohibited to
drill into or grind these rails.
!! Only people trained by Heras are allowed to disassemble the bottom
rail.
If the gate is damaged, always contact the supplier for an inspection.