(
Ⅳ
) Operation
4.1: Initialize the lock
Connect the button and the power supply pin before you install the lock (Green and
Red lights flicker with a sound “di”, when it is succeed in connecting the power). Then
press the button and connect the thimble (S1) until the green and red lights intervein
flicker with one sound of “di”. (The lock has been initialized at this time).There is no
address, unlock record and card data in the lock under the initialization state. In this state,
the red light will flicker two times with two short sounds “di”, “di” when the locks read
cards.
PCB Board Line Connection
4.2: Issue Management Card
Connect the thimble (S1) shortly till the green light turns on with a long sound “di—“.
Put the ID cards to the inductor. This ID card (Management Card) can be setup
successfully when the green light shining three times and alarms with a short sound “di”.
Note: One lock can be setup Management Card. When you lost the management card
you must setup a new management card. The old one can be deleted automatically
4.3: Issue User Cards
Put the Management Card close to inductor. Remove it when the green light turns on
with the short sound “di”. Put the Management Card close to inductor again before the
green light turns off, you will hear one long sound of “di” and see the green and red light
flicker. (Or keep the Management Card closing the inductor till the green light turns on
with a long sound “di—“.) The lock enters setup or deletes user cards estate.
Put the new ID card close to the inductor. This new ID card is setup successfully when
the green light flickers two times with one short sound of “di”.(If it comes with two short
sound “di” and no light flickers. It is fail to setup user card).You can still to setup user
cards during the green and red light flicker. It quits the setup user card estate when the
green light turns off with one long sound of “di—“. One lock can be set 255 user cards.
The red light will flicker three times with three sounds of “di” when it is full.
4.4: Delete some user cards
Put the management card close to the inductor and remove it when the green light
turns on with one sound of “di”. Before green light turns off, put the management card
close to the inductor again.
Then the green and red lights flicker with a long sound of “di”
.
(Or keep the
Management Card closing the inductor till the green light turns on with a long sound
“di—“.) The lock enters deletion card estate.
Put the user cards which need to delete close to the inductor. The red light flickers two
Close button
Battery Lines
Red
（＋
Pole
）
Black
（－
Pole
）
Setup Pin
4P Motor Lines
Connect
Lock
body’s
motor
Button Lines
Connect Shutdown Button
