Hensel Pro MINI 1200 AS, Руководство пользователя

Страница: 34 / 48

User manual // Pro Mini 1200 AS Power Pack
34
HENSEL-VISIT International GmbH
6 Starting up
Safety hints for operation with connected flash heads
To avoid damage to the flash tube, mount reflectors and
lightformers (softboxes etc.)
before use and turning on
the unit. Do not move power packs and lamp heads
around while they are operating. Turn the appliance off
for each change of reflectors or to move the unit to
another location.
Caution:
Reflectors, speedrings and other accessories heat up
during longer operation. To avoid injuries, handle with
isolating cloth or wait until parts have cooled down
.
A damaged flash tube is extremely dangerous be-
cause the electrically charged electrodes are ex-
posed and could be touched.
In case of a damaged flash tube, the flash head has
to be unplugged from the power pack immediately
because the capacitors inside the power pack may
still be charged and dangerous high voltage can still
be present at the damaged flash tube electrodes. The
appliance has to be sent to an authorized HENSEL
service department. For replacement of flash tubes
please consult your local HENSEL agency.
Assembly
When mounting to a ceiling system or a pantograph,
suspended flash heads have to be doubly secured from
falling down. This is done by tightening the safety screw
on the HENSEL U-bracket or the wrench screw on the
HENSEL tilting head. Due to the existing safety re-
gulations, it is, however, necessary to use a safety rope
(Code No. 769) for further security.
The safety rope has to be led through the handle of the
flash head and then secured by looping through the
bracket on the pantograph or the eyelet on the carriage.
Heating
Due to the modeling and flash light, each power pack and
flash head emits heat. This can heat the parts of the unit
up to a dangerous level. Therefore make sure that power
packs and lamp heads are located far enough from
inflammable props to avoid inflaming them.