User Manual Expert D 500/1000
17
HENSEL-VISIT GmbH & Co. KG
The compact flash unit can be used in any position. Please note
that extremely tilted positions can lead to rapid warming of the
unit, especially in connection with narrow-angle reflectors. In
extreme cases, the result can be a thermal safety shut off!
Repositioning tilting bracket/handle
The position of the tilting bracket and the handle can be swap
-
ped. This lets you mount the flash unit in an overhead location
like a ceiling.
How to swap tilting bracket and handle:
Â
Loosen the two crosshead screws on the tilting bracket/
handle.
Â
Slide the tilting bracket/handle forward along the guide rail
of the housing.
Â
Insert the tilting bracket/handle into the guide rail on the
opposite side of the housing.
Â
Tighten fast the two screws of the tilting bracket/handle.
Note:
Depending on the type of reflector attached, the position of
the tilting bracket/handle can be moved to the unit’s center of
gravity.
Power supply
ATTENTION!
Make sure that the power supply corresponds to the informa-
tion on the type label/technical data sheet before connecting
the compact flash unit to the power supply. Compact flash units
must only be connected to a grounded power supply.
The type label is located at the bottom of the housing. The com
-
pact flash
Expert D 500/1000
is solely approved for use with
115 V - 230 V / 50-60 hz operation.
It features multivoltage technology which means the unit auto
-
matically adjusts to the applicable voltage (110 V - 240 V).
