Operating the device
41
Radio remote trigger
The device has a built-in radio receiver. With the optionally available radio
remote trigger, the camera and flash can be synchronized by radio. To
activate the radio receiver, proceed as follows:
Press the SYNC button.
The LED display next to the SYNC button lights up red. The radio receiver is
activated.
Now select the desired channel 1–16 on the RF CH switch with the
provided tool.
Ensure that this channel is also set on the transmitter.
To deactivate the radio receiver, proceed as follows:
Press the SYNC button three times.
The LED display next to the SYNC button goes out. The radio receiver is
deactivated.
Activating and deactivating the photo cell
To activate the photo cell, proceed as follows:
Press the SYNC button twice.
The LED display next to the SYNC button lights up green. The photo cell is
activated.
To deactivate the photo cell, proceed as follows:
Press the SYNC button again twice.
The LED display next to the SYNC button goes out. The photo cell is
deactivated.
The flash is triggered through the photo cell by the striking of a flash
emitted by another device. The photo cell functions as a pulse photo
cell. It works only if the light output of the emitted flash is stronger
than the available light. For this reason, you must ensure that
excessively strong extraneous light does not affect the photo cell. In
such cases, the flash must be triggered either using the sync cord or
the radio remote trigger.
