> Once the user sets the mode, press Time button for longer than 2 seconds (till the num-
ber shown in the LED panel starts to blink), and press again to add time, a second per push.
> Operating time will start add up after one second if the user pushes the Time-button
continuosly.
> After setting up the Mode selection and operating, triggers the start button for start.
> Press again to stop operation at any time.
> Auto Power Saving Mode: the device will turn off automatically if not used for longer
than 90 seconds. Operation resumes once the user presses the start button again.
> In “Mode 1,8 second” setting, the cycles can be utilized 30 consecutive cycle contin-
uosly. Caution: If operate HS-LED 1200 for longer than 30 cycles (mode 1 8-second)
continuosly could result high heat that is hazardous to the heat of patients s teeth.
1. Choose Mode 1
2. Install the fiber Optic.
3. Aim the tip at the sensor and press Start, to start checking the light intensity.
The HS-LED 1200 is equipped with a special built-in magnetic fan motor to prevent over-
heating and to prolong the light emitting time.
COOLING SYSTEM :
SENSOR (RADIOMETER) :
TIME SETTING :
OPERATION :
6
IMPORTANT :
> The cooling system will be activated
when the heat starts to accumulate.
> If the system is over heated,
HS LED 1200 will be turned off
automatically for safety purpose.
Over-heating indication
