Henny Penny Velocity OXE-100, Инструкции по эксплуатации

Страница: 111 / 118

Annual
Inspection
Checklist
Form
99
C Ch ha ap ptte err 1 11 1 A An nn nu ua all IIn nssp pe eccttiio on n
C Ch he ecckklliisstt F Fo orrm m
Perform the following annual inspection in the order provided.
*Critical Item - Take fryer out of service until repaired.
T Ta ab blle e 1 11 1--1 1 A An nn nu ua all IIn nssp pe eccttiio on n C Ch he ecckklliisstt
# #
A Asssse essss V Va att a an nd d F Frra am me e ((rre em mo ovve e rre ea arr cco ovve err a an nd d b bo otth h ssiid de e
p pa an ne ellss))
O OK K C Clle ea an n R Re ep plla acce e
1.*
Inspect the fry pot for leaks or oil accumulation.
2.
Ensure the fryer sits level. Inspect the casters and fryer frame
for damage.
3.*
Inspect the electrical cord and plug.
4.*
Inspect lid cables as per instructions for this step.
5.
Check that the counterweight frame hangs level.
6.
Inspect and lubricate lid carriage rollers and cable pulleys.
Make sure the lid moves up and down freely.
7.
Inspect lid wiring for damage or excessive wear from lid pin
switch to left side panel.
8.
Replace filter pump seals and rollers.
9.
Clean and replace the Nylatron slides as necessary.
Behind Service Access Panel - Pressure System
10.
Inspect the steam exhaust hose insert.
11.
Remove the condensation box cover. Inspect the condensation
box gasket, deadweight, and orifice. Inspect and clean the con-
densation drain hose. Ensure each component is in good work-
ing condition. Clean and re-install all components after step 13
is complete.
12.
Clean the Safety Relief Valve – Install only after step 13 is
complete.
13.
Remove the solenoid valve and clean and reassemble. Install
only after step 13 is complete.
14.
Remove all pressure system tubing. Inspect, clean, or replace
any tubing or fitting that is blocked, or obstructed. If leaking is
found at any fitting, clean and replace the compression fitting.
Filter Components and Drain Oil