Henny Penny LVE-202, Техническое руководство

Страница: 86 / 115

Maintenance
74
S SH HO OC CK K H HA AZ ZA AR RD D T To o a avvo oiid d e elle eccttrriicca all
ssh ho occkk,, m mo ovve e tth he e p po ow we err ssw wiittcch h tto o o offff a an nd d
d diisscco on nn ne ecctt m ma aiin n cciirrccu uiitt b brre ea akke err,, o orr u un n--
p pllu ug g cca arrd d a att w wa allll rre ecce ep ptta acclle e..
1 1))
Support control panel bottom with one hand, loosen retaining screw at panel
top, slide panel down slightly to clear screw, push panel back up, then swing
panel top out and down.
2 2))
Locate the 8-pin connector ont he AIF PC board and pull the connector from the
board.
3 3))
Check for proper continuity between the pins with wires labeled D1 and D2.
Switch can fail “open” or “closed”. If drain pan switch is defective, continue with
replacement instructions below.
7 7..2 21 1..1 1 R Re em mo ovva all
1 1))
Drain pan switch is located under right frame rail on which drain pan slides.
Using a “stubby” 3/8 inch nut driver or socket, remove two nuts securing switch
to frame.
2 2))
Using same tool, remove three nuts and wire clamps from under frame rail.
3 3))
Separate connector between the right and center doors (below magnets) and
push plug down through frame rail.
4 4))
Mount new switch under rail and secure with two nuts. Route wires through
clamps, secure clamps to studs with nuts, and push plug up through rail and
connect.