Henny Penny LVE-202, Техническое руководство

Страница: 33 / 115

Level
3
Programming
21
C Ch ha ap ptte err 5 5 L Le evve ell 3 3
P Prro og grra am mm miin ng g
Used to access the following:
• TECH RESETS - Reset recovery faults/password to default.
• SPCL PROG - Program filter control parameters and other items.
• CLOCK SET - Set the time-of-day clock/calendar.
• DATA COMM - Data communications, MMC, etc.
• HEAT CTRL - Program heat algorithm control parameters.
• TECH MODE - Control of outputs, display, and button tests, etc.
• STATS MODE - Review, reset operating stats, diagnostic logs, etc.
5 5..1 1 A Ad dd diittiio on na all A Ad dvva an ncce ed d P Prro od du ucctt S Se ettttiin ng gss
1 1))
Press and hold the temp and info buttons until “LEVEL - 3” shows in the display,
followed by “ENTER CODE”.
2 2))
Enter code 1, 1, 2, 2, 1, 1, 2, 2 (first two product buttons), and “A. TECH”
“RESETS” shows in the display.
T Te ecch h R Re esse ettss
3 3))
Press right ✓ button and “RECOVERY FAULTS” shows in the left display. The
right display shows “CLR” and the number of recovery errors recorded. Press ✓
to reset the number to “0”.
4 4))
Press the down arrow and “ALL PASSWORDS RESET” shows in the left
display. Press ✓ to reset all the passwords set in the controls.
NOTE:
• Use the up button to go back to previous menu items.
• Press “X”, when finished with the current item, to return to the main menu.
• Press “X” a second time to exit Level 3 programming.
5 5..2 2 S Sp pe ecciia all P Prro og grra am mm miin ng g
The Special Program Mode is used to set more detailed programming. Prior to
accessing individual program modes, see the following procedure.
1 1))
Press and hold the temp and info button until “LEVEL - 3” shows in the display,
followed by “ENTER CODE”.
2 2))
Enter code 1, 1, 2, 2, 1, 1, 2, 2 (first two product buttons).
3 3))
“A. TECH” “RESETS” shows in the display. Press the down arrow and “B.
SPCL” “PROG” shows in the display.