ii • 2800/2801 Lathe Enclosures
Table of Contents
Definitions of Hazard Levels .................................................ii
Owner’s Responsibility ..........................................................ii
General Safety Instructions .................................................iii
Before You Begin .....................................................................1
Safety Notices and Decals ............................................1
Cautions and Dangers ....................................................1
Receiving ..........................................................................2
Installation – 2800 and 2801 ...................................................3
Unpacking the Enclosure ...............................................3
Preparing the Bench for Installation ............................3
Assembling and Installing the Enclosure ....................3
Additional Installation – 2801 only .......................................6
Assembling Shield ...........................................................6
Electrical Wiring ..............................................................6
Operation ...................................................................................7
Maintenance ............................................................................7
Parts Identification 2800 and 2801 ........................................8
Parts Identification – 2801 parts only ..................................8
Shield Assembly ..............................................................8
Wiring View ......................................................................9
Hood Switch Mounting ...................................................9
Foot Switch Assembly (assy part #40044) ...................9
Magnet Mounting ............................................................9
Stop Switch Mounting ....................................................9
Definitions of Hazard Levels
Identify the hazard levels used in this manual with the
following definitions and signal words:
DANGER
Watch for this symbol:
It Means: Immediate hazards which will result in severe
personal injury or death.
WARNING
Watch for this symbol:
It Means: Hazards or unsafe practices which could result
in severe personal injury or death.
CAUTION
Watch for this symbol:
It Means: Hazards or unsafe practices which could result
in minor personal injury or product or property damage.
Watch for this symbol. It means BE ALERT! Your safety, or
the safety of others, is involved.
Owner’s Responsibility
To maintain machine and user safety, the responsibility of
the owner is to read and follow these instructions:
•
Follow all installation instructions and make sure
installation conforms to all applicable Local, State,
and Federal Codes, Rules, and Regulations; such as
State and Federal OSHA Regulations and Electrical
Codes.
•
Carefully check the unit for correct initial function.
•
Read and follow the safety instructions. Keep them
readily available for machine operators.
•
Make certain all operators are properly trained, know
how to safely and correctly operate the unit, and are
properly supervised.
•
Allow unit operation only with all parts in place and
operating safely.
•
Carefully inspect the unit on a regular basis and
perform all maintenance as required.
•
Service and maintain the unit only with authorized or
approved replacement parts.
•
Keep all instructions permanently with the unit and all
decals/labels/notices on the unit clean and visible.
Failure to follow danger,
warning
and
caution
instructions may lead to
serious personal injury to operator or bystander, or
damage to property. Do not operate this machine until
you read and understand all the dangers, warnings and
cautions in this manual. For additional copies of either,
or further information, contact:
Hennessy Industries
P.O. Box 3002, 1601 J.P. Hennessy Drive
LaVergne, TN 37086-1982
615/641-7533 or 800/688-6359
WARNING
DANGER
WARNING
CAUTION
