Installation:
1.Replace the existing door viewer or drill a 14mm hole in the door
at the required height, insert the camera from the outside . Making
sure the washer is fitted between. The camera and the door. Ensure
the bell push is at the bottom and adjust so that the camera is
perpendicular
2.Peel off the 3M stickers on the holding plate and fit it over the end
of the lens, then screw the locking barrel on to the threaded sleeve
of the camera and tighten. This will hold the plate to the door. Make
sure that the arrow on the plate points upwards.
3.The data wire should be fully plugged in at the back of the screen;
excess wire should be gently placed into the groove at the back of
the screen.
4.Hook the screen over the bracket at the top of the plate and secure
with one small screw through the hole at the bottom of the screen
case.
to the horizon.
hook the screen
case
fix the screw
3
DOOR
