Hendi 235973, Руководство пользователя, Страница: 9 / 24

9
3d. Installation:
Fasten the dispenser with fi xed fl ow rate
using the holes (diameter: 4 mm) with a cen-
tre distance of 60 mm.
Fasten the dispenser with adjustable fl ow
rate using the holes (diameter: 4 mm)
with a centre distance of 42 mm. You can use the bracket to trace the holes.
When you are done fastening the brack-
et, assemble the dispenser. Insert the
guides in the back of the dispenser with
the guides on the bracket and push it until
it comes to its limit stop.
Diagram for fastening of adjustable fl ow-rate dispensers.
DISPENSER WITH ADJUSTABLE FLOW RATE
4. Flow rate adjustment: Tighten the screw (3-6) by turning it clockwise to increase
the dosage, and counterclockwise to decrease it.
4a. Rinse aid dosing cycle adjustment:
Tighten the screw (6) to adjust the cycle
time. The cycle pause/run mode repeats
continuously until power cut-out.
The operator can set a cycle time ranging
from 0 to 7”; if you adjust the cycle to its
minimum run time, the dispenser will not
dispense any product, while if you adjust
to its maximum run time, the dispenser
works in continuous cycle.
EN