Henden HMSC20, Инструкция по установке и эксплуатации, Страница: 7 / 20

Henden Mineral and Salt Chlorinator Installation Manual
HENDEN INSTALLATION & OWNERS MANUAL | 7
1.5 Pre-start up procedure
Before operating your Henden Pool Sanitiser System
please ensure the following quantity of Pool Salt or
mineral salt (HMS15) and mineral activator (HMA15)
has been added to your pool.
POOL SALT
SALT LEVEL GUIDE – 20kg Bag
To raise salt
concentration by
Salt Required
ppm %
25,000L
Bags / kg
30,000L
Bags / kg
35,000L
Bags / kg
40,000L
Bags / kg
45,000L
Bags / kg
50,000L
Bags / kg
55,000L
Bags / kg
60,000L
Bags / kg
65,000L
Bags / kg
70,000L
Bags / kg
1000 0.1 1.3 / 26 1.5 / 30 1.8 / 36 2.0 / 40 2.3 / 46 2.5 / 50 2.8 / 56 3.0 / 60 3.3 / 66 3.5 / 70
2000 0.2 2.4 / 48 2.8 / 56 3.3 / 66 3.7 / 74 4.2 / 84 4.6 / 92 5.1 / 102 5.5 / 110 6.0 / 120 6.4 / 128
3000 0.3 3.6 / 72 4.4 / 88 5.1 / 102 5.9 / 118 6.6 / 132 7.4 / 148 8.1 / 162 8.9 / 178 9.6 / 192 10.4 / 208
4000 0.4 5.0 / 100 6.0 / 120 7.0 / 140 8.0 / 160 9.0 / 180 10.0 / 200 11.0 / 220 12.0 / 240 13.0 / 260 14.0 / 280
5000 0.5 6.3 / 126 7.5 / 150 8.8 / 176 10.0 / 200 11.3 / 226 12.5 / 250 13.8 / 276 15.0 / 300 16.3 / 326 17.5 / 350
6000 0.6 7.3 / 146 8.8 / 176 10.3 / 206 11.8 / 236 13.3 / 266 14.8 / 296 16.3 / 326 17.8 / 356 19.3 / 386 20.8 / 416
1.6 Storage and safety
1. Store in a dry, covered place away from direct
sunlight for longer bag life
2. Always use the entire bag content of salt, once
opened. Do not keep open bags of pool salt, as it is
sensitive to moisture in the air.
3. Care should be taken to avoid contact with eyes and
inhaling salt dust. Wearing eye protection and a dust
mask is good practice.
4. If eyes become affected, flush with clean tap water.
5. If skin becomes irritated, immediately wash
contaminated skin with plenty of water and then wash
with soap and water.
CHLORINE - For a new pool installation that has not been
chlorinated, add sufficient chlorine (liquid or granular) to
achieve a reading of 3 ppm (with a suitable test kit), or run
the sanitiser system continuously for at least 24 hours or
until a reading of 3 ppm is reached.
STABILISER - It is essential that pool stabiliser be added
and maintained at the rate of 30 - 50 ppm at all times. Do
not exceed 100 ppm.
(FOR OUTDOOR POOLS ONLY)
(Refer Day to Day Operation page 16 for further
information).