- 2 -
Installation:
Install the AutoMate interface onto the sprayer with the following steps.
1. Remove the four screws securing
the boom switch control panel on
the right console in the sprayer
cab.
Fig. 1: Boom switch control panel
2. Raise the boom switch panel and
locate the four connections for
each switch.
Each boom switch will have two
signal wires (yellow), a ground
(white), and a power (orange).
One of the signal wires will have
an additional wire piggy-backed
onto the same spade connection.
This is the positive boom signal
connection.
Fig. 2: Boom switch wiring
Screws
Positive Signal
Wire
Ground
Boom Switch 1
Negative Signal
Wire
