Helvi GLOBUS 175HF, Инструкция по эксплуатации

Страница: 23 / 60

1.0 INTRODUCTION
1.1 Equipment identification
The unit’s identification number (specification or part number) model, and serial number
usually appear on a nameplate attached to the rear panel. Equipment which does not
have a control panel such as gun and cable assemblies is identified only by the specification
or part number printed on the shipping container. Record these numbers for future reference.
1.2 Receipt of equipment
When you receive the equipment, compare it with the invoice to make sure it is complete
and inspect the equipment for possible damage due to shipping. All machines dispatched
have been scrupulously checked. However, should your machine not work properly, consult
your authorized dealer.
2.0 SAFETY WARNING
2.1 General instructions
This manual contains all the necessary instructions for:
- the installation of the equipment;
- a correct operating procedure;
- an adequate maintenance of the equipment.
Therefore, be sure this manual is carefully read and understood by the maintenance and
technical operators.
2.2 Location
Welding processes of any kind can be dangerous not only to the operator but to any
person situated near the equipment if safety and operating rules are not strictly observed.
Therefore the owner and the operator must be
aware of all possible risks so that they may take
the necessary safety precautions to avoid any
kind of accident at work.
The main precautions to be observed are:
-Operators should protect their body by wearing
non flammable, close fitting protective clothing,
without pockets or turned-up trousers. Oil or
grease should be carefully removed from all
articles, before wearing. Operators should also
wear closed safety boots with steel toe caps and
with rubber soles ( Fig. 1).
1. Leather gloves
2. Leather aprons
3. Shoes cover
4. Security shoes
5. Face masks
FIG.1