helvenco AERO 1000, Руководство пользователя, Страница: 26 / 28

26
Speed Conversion table
Propeller pulley PTO pulley Ratio
Engine rpm Aera of maximum
7000 7500 8000 8500 9000 9500 10000 Torque
210
50 4,20 1667 1786 1905 2024 2143 2262 2381
Propeller speed
52,5 4,00 1750 1875 2000 2125 2250 2375 2500
55 3,82 1833 1964 2095 2226 2357 2488 2619
58,25 3,61 1942 2080 2219 2358 2496 2635 2774
61,75 3,40 2058 2205 2352 2499 2646 2793 2940
230
50 4,60 1522 1630 1739 1848 1957 2065 2174
52,5 4,38 1598 1712 1826 1940 2054 2168 2283
55 4,18 1674 1793 1913 2033 2152 2272 2391
58,25 3,95 1773 1899 2026 2153 2279 2406 2533
61,75 3,72 1879 2014 2148 2282 2416 2551 2685
Reset ECU DTC codes
When a sensor or its connection fails, a DTC (Diagnostic trouble code) is written into the ECUs memory.
This error code can create mal behaviour of the software, therefore it can be helpful to do the following procedure:
1. Turn on the ignition by moving the start witch into the middle position.
The fuel pump should run now for 5 sec. if not check if ECU is connected!
2. Wait 5 seconds before to go to the next action!
3. Turn ignition off
4. After 5 seconds move start switch 3 times as follow:
•
Ignition on/off + on/off + on/off
5. Wait 10 seconds
6. Ign ition “O n ”
7. Wait 5 second to start.
This is just a reboot of the ECU, the mapping will not be removed or erased!