Heltun HE-FT01, Быстрый старт

Страница: 10 / 92

SmartStart
SmartStart-enabled products can be added to a Z-Wave network by scanning the Z-Wave QR Code shown on the product with
gateways/controllers that provide for SmartStart inclusion. In this case, no further action will be required and the SmartStart product will
be added automatically within ten minutes of being turned on in the vicinity of a network.
To add the HE-FT01 to the Z-Wave network using SmartStart:
Note: The device security code (DSK) and SmartStart QR code are printed on the HE-FT01 back panel plus on the included Security Card
(see Figures 9 & 10).
Z-WAVE NETWORK
The HE-FT01 may be operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers. The HELTUN HE-FT01
will act as a ‘repeater’ for other devices regardless of manufacturer or brand to increase the reliability of the overall network.
Frequency Region
The Parameter 1 (“ Eg”) allows you to manually change the Z-Wave frequency which is mandated in your geographical region.
Modification is possible only while the HE-FT01 is in a ‘Non-Included State.’ While in an ‘Included State’, the Antenna icon will be
shown at the bottom right corner of the LCD screen and modification of this Parameter will be disabled. To navigate through the different
values, use the Plus (+) and Minus (–) buttons. After the Frequency Region has been selected, hold the Clock button to save the
Parameter value and reboot the device for the new settings to take effect.
Security
S0, S2 unauthorized, and S2 authorized Inclusion Modes are supported. If you use the S2 authorized Inclusion Mode the security key
should be used during the inclusion process. The Security Key is printed on a card located with this quick start guide and also on the
HE-FT01 backplate (see Figures 9 & 10).
Note:
Be sure to save this key. Without the key, it is impossible to perform an Inclusion in S2 authorized mode.
1.
2.
3. To disassemble, ENSURE POWER IS SWITCHED OFF at the main circuit breaker AND THE LCD SCREEN IS BLANK.
To remove the HE-FT01 display unit grasp firmly at the bottom and pull backwards while tilting outwards until all tabs disconnect.
Remove screws from backplate and disconnect the wires by inserting a small Phillips-head screwdriver into the slot beneath each wire
and unscrewing to release.
DISASSEMBLY
1.
2.
3.
4.
5.
Set the main controller in Security S2 Authenticated “Add Mode”.
Input the thermostat DSK to the controller (or scan the QR code).
Power on the device.
Wait for the adding process to complete.
Successful adding will be confirmed by displaying the Antenna with signal strength bars icon in the bottom right corner of
the main screen.