What’s in the box?
Firstly, insert the spine
tube
(b)
into the base
tube of the chassis
(a)
,
but before securing in to
place,
pull up & fasten
the mesh bag over the
2
prongs
at the top end of
the spine tube.
Secondly, proceed to
tighten the M8 screw
and associated fittings
as shown in figure 1,
using the Allen key
and spanner provided.
Then securely put the
nut cover in place.
Thirdly, insert the
handle
(c)
into the
spine tube
(b)
and
adjust to your desired
height and orientation
and
secure
using the
linchpin as shown in
figure 2.
To fit the bag, first pull
on tabs to release the
elasticated cord (fig.1)
Push through an open
bin bag, smooth round
the edges and fasten
securely with the
retainer cord (fig.2)
h
- Linchpin
a
- Chassis - consisting of main frame and base tube (
part code: LP0004
), and mesh bag
(LP0005)
b
- Spine tube
c
- Handle (
LP0006
)
e
- HandiHoop Plus x2 (
LP0001
)
f
- 13mm spanner
g
- 5mm Allen key
j
- M8 nylon nut
k
- Steel washer
l
- Nut cover
i
j
h
g
f
k
l
e
M8 screw (i)
Steel washer (k)
M8 nylon nut (j)
& nut cover (l)
Linchpin (h)
Handle (c)
Spine tube
(b)
i
- M8 screw
Pic 2
Pic 1
To finish, place each
of the
on to the fixed holders
as shown here.
a
c
Fig. 2
spine
tube
base
tube
Fig. 1
b
d
d-Wheels
(LP0007)
Fig.1
Fig. 2
Assembly Instructions
Step 1
Step 5
Step 4
Step 3
Step 2
