2.6 Electric heating toggle
Electric heating toggle applies to homes with an electric heating system.
The sauna heater thermostat also controls the heating toggle. In other words, home heating turns on once the sauna ther-
mostat cuts power off the sauna heater.
2.7 If the sauna heater will not heat up
If the sauna heater will not heat up, please check that:
1. The power is on;
2. The timer is on the heating zone (operating zone);
3. The thermostat is switched to a temperature that is higher than the current temperature of the sauna room;
4. The front fuses of the sauna heater are intact;
5. The timer is not stuck. Make sure the knob doesn't chafe against the base; there should be min 1mm gap between the
knob and the base.
If the sauna heater has been exposed to freezing conditions, the temperature limiter may have gone off. The limiter is reset
by pressing the reset switch. Note that the limiter does not work until the temperature has risen to approx. -
heater still fails to work, please contact an authorised service for repair.
3 Instructions for heater installation
THE PERSON INSTALLING THE SAUNA HEATER SHOULD LEAVE THESE INSTRUCTIONS TO THE PREMISES FOR
THE FUTURE USER.
3.1 Preparing for sauna heater installation
Check the following before installing the sauna heater:
1. The ratio of the heater's input (kW) and the sauna room's volume (m
3
). Volume/input recommendations are
presented in Table 1 on page 9. The minimum and maximum volumes must not be exceeded.
2. The sauna room ceiling must be min 1900 mm high.
3. Uninsulated and masonry stone walls extend the preheating time. Each square metre of plastered ceiling or
wall surface adds 1.2 m
3
to the sauna room's volume.
4. Check page 11 Table 2 section for a suitable fuse size (A) and the correct diameter of the power supply
stion.
5. Conform to the specified safety clearance around the sauna heater. Please refer to Image 2 Sauna heater
safety clearances. There should be enough room around the sauna heater for maintenance purposes, a
doorway etc.
3.2 Installation
Follow the safety clearance specifications on page 9 when installing the sauna heater. Thin panel is not a suitable mounting
base. The mounting base must be reinforced with timber behind the panel. The minimum clearances specified on page 9
table 1 must be followed also in case the sauna room wall materials are incombustible.
Walls or ceilings must not be clad with fibre-reinforced plaster board or other light-weight cladding, because they may cause
a fire hazard.
A single sauna heater is allowed per a sauna room.
Product Manual
Ring Wall STJ
7
