Helm Trend Loadgard TLG2300, Руководство по эксплуатации

Страница: 24 / 46

OPERATING INSTRUCTIONS TREND SERIES
FRONT PANEL PUSH BUTTONS
ALARM RESET
Pressing this switch initiates a Peak reset for any alarm condition. This switch is only active when keyswitch
is in SETUP or MONITOR PARTS RESET ACTIVE position.
CAPACITY ALARMS
Press the CAPACITY ALARMS button to any operating mode to display the capacity alarm setting on each
channel. On single meter systems, press and hold the appropriate channel display button.
STROKES PER MINUTE
SPM is calculated and displayed when function keyswitch is in Monitor Parts position. While the machine is
producing parts, press and hold STROKES PER MINUTE button to display machine operating speed on
center meter. Two machine cycles are required before SPM is displayed.
TOLERANCE ALARMS
Press the TOLERANCE ALARMS button to display high and low tolerance setting. The first two digits
represent the high tolerance setting; the second 2 digits represent the low tolerance setting. A display of
2010 represents tolerance settings of 20% high and 10% low. On single meter instruments press and hold
the appropriate DISPLAY button.
REVERSE LOAD
With function selector in Monitor Parts position, the reverse (snap-thru) tonnage imposed on each channel
plus total machine is displayed when this button is pressed.
TARGET LOAD
When using Job Data Control (JDC) feature, the TARGET LOAD for each channel (and total) is displayed
with this push button.
20