•
Remove all the packing material.
•
Check and ensure the all the installation parts as per instruction manual are included in the packaging. If anything
is missing, please contact the retailer immediately.
INSTALLATION / MOUNTING INSTRUCTIONS
•
This panel convector heater is suitable for wall- mounting as well as free-standing on supplied legs/feet.
•
For Free-standing, mount the supplied feet/legs on the main heater body in accordance with Figure G1.
•
For wall mounting, please refer to the Figure G2.
a)
The heater should be mounted at least 15 cm above the floor and there should be at least 60cm clearance
between the top of the heater and the ceiling.
b)
Uninstall/remove the bracket from the back of the heater by removing two holding screws on top of the
bracket. See Images 1.
c)
Mark intended location, drill required holes on the wall and insert the supplied plastic expanded plugs, then
install the bracket on the wall using the supplied 4 X mounting screws. See the Image 2.
d)
Fix the heater into the bracket (mount from bottom bracket first then the top until you hear the top latches
clicking into place). See Images 3.
e)
Reinstall and tighten the holding screws on the top of bracket to secure the heater onto the bracket. See
Images 4.
Figure G1
Image 2
Image 3
Image 4
Image 5
Figure G2
OPERATION OF THIS PRODUCT
•
If not wall mounted, place the heater on flat, stable surface.
•
Switch thermostat knob in off position.
•
Plug the heater in.
