THERMOSTAT
Set the thermostat to "max." and operate the appliance until the desired room
temperature is reached. Turn the thermostat anticlockwise until the appliance
switches off with an audible "click".
This set temperature will be kept almost constant by the appliance switching on and
off automatically.Please note that the appliance does not switch on unless the
thermostat setting is higher than the room temperature.
OSCILLATION:
Turn on and off oscillation function using the oscillation switch located at the back of the heater.
“O” ----- OSCILLATION OFF
“－”
----- OSCILLATION ON
TIP-OVER PROTECTION
This heater is protected with a safety switch that turns off the appliance automatically when the heater
falls over, or is at an excessive angle from the horizontal. This helps prevent accidents, and the heater
will resume operation when it is put back upright.
OVERHEAT PROTECTION
This heater is protected with thermal cutoff protection that switches off heating automatically in case of
severe overheating. eg. something covering the heater. In this case, waiting to the appliance cool and
removing the objects. Then the thermal cutoff will automatically reset, heating as normally. Check for
damage to the appliance, the cord and the plug. If there is no damage, plug the unit back in and switch it
on as described above. If the heater still does not turn on, please contact Customer Service for
assistance.
CLEANING & MAINTENANCE
The heater requires regular cleaning to ensure trouble free operation:
•
Unplug the heater from the mains supply before cleaning.
•
Ensure that the heater has been allowed to cool before cleaning.
•
Use a damp cloth (not wet) to wipe the exterior of the heater to remove dust and dirt.
•
Do not allow any water or other liquid to enter the housing or control panel.
•
Ensure the heater is dry before plugging back into the mains supply.
CAUTION: Do not use harsh detergents, chemical cleaners or solvents as they may damage the
surface finish of the heater.
