HELIX V TWELVE DSP, Руководство пользователя

Страница: 28 / 48

26
the booting process of the DSP is completed. Ad-
ditionally this output will be turned off during the
“Power Save Mode” or a software update process.
7 Highlevel Input
12-channel highlevel loudspeaker input to connect
the amplifier directly to loudspeaker outputs of
OEM / aftermarket radios or OEM amplifiers that do
not have any pre-amplifier outputs. Input sensitivity
is factory-set to 11 Volts (see the following picture).
However, it is possible to optimally adapt the in-
put sensitivity to the signal source using control 10
(
Gain
) and by repositioning jumpers inside the de-
vice (see page 28, item 4; Adjustment of the input
sensitivity).
Important: It is mandatory to properly adapt the
input sensitivity of the V TWELVE DSP to the
signal source before first use. Disregarding this
may cause severe damage to the amplifier..
Attention: Solely use the pluggable screw-termi-
nals for the highlevel connectors which are included
in delivery or an optional available cable harness
from the HELIX accessory assortment!
Important: It is strictly forbidden to use the
High-
level Input
and lowlevel
Line Input
of an individual
channel at the same time as this may cause severe
damage to the lowlevel line outputs of your car ra-
dio. Nevertheless it is possible to use the
Highlevel
Input
of one channel and the lowlevel
Line Input
of
another channel simultaneously.
8 Line Input
6-channel pre-amplifier input to connect signal
sourc es such as radios. Input sensitivity is
factory-set to approx. 3 Volts.
However, it is possible to optimally adapt the in-
put sensitivity to the signal source using control 10
(
Gain
) and by repositioning jumpers inside the de-
vice (see page 28, item 4; Adjustment of the input
sensitivity).
9 Clipping LED
This LED lights up red if one of the six
Line Inputs
or
12
Highlevel Inputs
is overdriven. The LED has no
function if the device is fed with digital input signals.
If this LED lights up reduce the input sensitivity by
using the control 10 (
Gain
) until the LED goes out.
10
Gain
This control is used to adapt the input sensitivity of
the low- and highlevel inputs to the output voltage
of the connected signal source. This is not a volume
control, it´s only for adjusting the amplifier gain. The
control range of the RCA /
Line Input
is factory-set
to 1 - 4 Volts and 4 - 16 Volts for the
Highlevel Input
.
The input sensitivity range can be changed by re-
positioning jumpers inside the device. Alternatively,
the input sensitivity can be set using the DSP PC-
Tool software. Therefore, the function has to be ac-
tivated and configured in the “Signal management”
tab of the DCM menu (see the following picture).
Important: If the input sensitivity of a channel
is set between 11 V and 32 V, it is mandatory
to reposition the jumpers inside the device to
Initial start-up and functions