HelioSphera HS Atlas Series, Инструкция по безопасности и установке

Страница: 19 / 51

10-SSI-001_rev.005_ENG
Page 19 of 51
maximum bending/deformation for both edges is 13 mm, and 11 mm respectively. No
buckling/twisting of more than 30 mm across the module diagonal.
4. All direct contact of the glass/solar module with metal parts of the substructure must be
prevented.
5.
The clamps’ width of contact must have a maximum of 14 mm and at least 12 mm.
See clamps’ draft with all the dimensions. (Fig. 16)
6. The solar module must run at stress-free and force-free conditions.
7. Accumulation of water at the solar module must be prevented; might cause corrosion
on the adhesive bonding or on the PVB foil between front and back glass.
8. The specified fixation points at the approved mounting assemblies are shown in Fig.
14 and Fig. 17.
The approved mounting system is described in Fig. 14. In Fig. 15 the clamps are shown
as a reference; they should not be taken as standards, because other dimensions are possible,
except for the dimensions marked in the figures (all in mm), these are mandatory to fulfill
HelioSphera installation requirements mentioned above.
1100 mm
310 mm
1300
mm
65
0
mm
Fig. 14 Mounting configuration
310 mm