TL64 Information
• Please read these instructions carefully before starting.
• This product will hold most 32-60 Flat Panel TVs.
• Load capacity: 40kg (88Lbs).
• VESA Compliant: 100x100, 200x200, 400x400, 600x400
Supplied Parts and Hardware:
(
Some parts not shown at same scale)
SAFETY WARNING:
Never let children climb on product or play with product.
Do not sit or stand on product.
Do not fasten a TV that is heavier than the recommended load rating to the mount.
Using suitable concrete wall or wood stud wall.
Improper installation may cause property damage and/or personal injury,so the installation
must be done by two qualified contractors. The manufacture is not liable for damage or
injury caused by incorrect mounting, assembly or use.
Improper handling can result in cuts and lacerations.
Pictures for reference only, subject to our available products.
Keep this instruction for future reference.
CAUTION :
CAUTION :
This mount is intended for use with weights not exceeding "maximum
weight capacity 88lbs." Pls don't over tighten screws in order to avoid any injury.
Use with products heavier than the maximum weights indicated may result in
collapse of the mount and its accessories causing possible injury.
Wall mounting hardware:
①
Part list
：
A-Wall plate 1pc
B-TV Bracket
2pcs
--Anchor
4pcs
--M8 washer
4pcs
--Lag bolt
4pcs
--Wrench
1pcs
--Allen Key
1pc
--Bubble level
1pc
TV mounting hardware
②
a--M4x12 bolt
4pcs
b--M5x12 bolt
4pcs
c--M6x12 bolt
4pcs
d--M8x16 bolt
4pcs
e--M4x30 bolt
4pcs
f--M5x30 bolt
4pcs
g--M6x35 bolt
4pcs
h--M8x40 bolt
4pcs
i--M4/M5
spacer 4pcs
j--M8/M6
spacer 4pcs
k--M4/M5
washer 4pcs
l--M6 washer
4pcs
Step 1
：
Pls remove the plaster board on the surface of concrete wall when assembling
mount on the concrete wall.
Hold Wall plate (A) against wall at desired position on concrete
wall, then using a pencil mark 4 hole locations. Then drill holes according pencil marks using
3/8"
size drill bit to a depth of 2.5". Then you will need to use wall anchors . Insert wall
anchors into holes, you may need to use hammer to lightly tap wall anchors into wall. Then
fix Wall plate (A) to the wall with screws and washers . (Figure 1)
CAUTION:
The concrete wall minimum thickness no less than 5.5 inches, and
surface covering can't more than 3/8 inches.
If you mount TV mount into wood studs ,pre-drill the mark 4 holes using
7/32"
drill bit to a
depth of 2.5", fix Wall plate (A) to the wall with screws and washers . (Figure 2)
CAUTION:
The wood stud min size is 2x4 inches, and surface covering can't more
than 5/8 inches. Drill hole on the wooden pillars middle line.
CAUTION:
Don't use it on the concrete block.
Concrete wall
No!
Level
A
Figure 1 (keep the Wall plate level)
3/8"
1