(3) DISPOSAL
The power tool, accessories and packaging materials
should be sorted for
environmental-friendly recycling.
Do not dispose of power tools into household waste!
According the European Guideline 2002/96/EC for Waste Electrical and
Electronic Equipment and its implementation into national right, power tools
that are no longer usable must be collected separately and disposed of in an
environmentally correct manner.
7. Troubleshooting
(1) The strap slips while tensioning
a. Tension
force
setting is
higher than
the Strap Strength. Please turn down the tension
(refer to Page no.6 in Part I of Manual).
b. There is too much strap debris on the teeth of the Tensioning Wheel (H45-10090) or
Gripper (H45-10070)
c. Strap Stop (H45-10280/H45-10281) touches the straps. (shown as following
drawing). Please clean the Strap Stop (H45-10280) and feed the strap appropriately
until the Strap Stop won’t affect the strap while tension.
Strap Stop touches the straps
touch the strap
H45-10280/10281
d. The Tensioning Wheel (H45-10090) or the Gripper’s (H45-10070/ H45-10071) teeth is
worn and need replacement.
(2) The strap can not be cut completely
a. The sealing time might be set too short.
b. The strap is not thread correctly so a small part of the strap is not cut completely.
c. The Shim (H45-40270) are too many or insufficient.
- 10 -
d. The Cutter (H45-40090) is worn.