Installation instructions Art. No
.
38226
Page 2 of 3
Status12.2014
Montage:
Installation must be carried out only by a qualified electrician.
Decide on the location where installation has to take place.
Never place the product near sources of heat, heating ovens, for example..
Make sure that the base is solid enough to guarantee firm, proper fixing of the LED set. Observe the
respective processing regulations.
The LED strips and the connection components are provided with double-sided adhesive tape on the
rear side.
Never let the LED set hang down or swing.
Do not switch the product on in a rolled up state.
Do not cover the LED strip or LED driver with decoration material or film.
Do not use any sharp-edged tools for installation. Do not hit the product with a hammer or other tools.
Do not kink the LED strip or cable; ensure that the LED strip, cable and plugs are free of tensile and
torsion forces. Protect the LED set against possible damage.
Handle the LED set only in a power-free condition.
The connection points and the interfaces at the LED strip have to be provided with extra insulation when
they are used in a wet or damp environment (shrink-on sleeve or cold shrinking, for example)
The type designation plate must not be removed.
RGB controls:
Remove the battery protection foil at the remote control unit.
The lighting is switched on and off with the remote control unit.
The battery has to be changed if it starts to lose power. Open the battery compartment on the lower side of
the remote control unit, remove the old battery and insert a new type CR 2025 3V button battery. Reclose
the battery compartment.
Heitronic
®
H. Vollmer GmbH
Allmendring 29
D-75203 Königsbach-Stein