Heitronic 37356, Инструкция по установке и эксплуатации

Страница: 6 / 35

H. Vollmer GmbH
Installation instructions Art. No: 37356+ 37358 Page 2 of 4 Status 21.12.2015
4. Before installation/commissioning

The LED-floodlight may only be operated after removing the packaging.

Take the LED-floodlight carefully out of the packaging.

Before commissioning the LED-floodlight make sure that it has not been damaged in transit. The LED-
floodlight must not be operated if the electrical components have been damaged. Repairs may only be
undertaken by a specialist electrician.

Keep the packaging material well away from children and household pets. Danger of suffocation!
5. Installation/Commissioning

This product may only be installed by a qualified specialist electrician.

Before the installation is done, the connection lines to the building must be disconnected from the
power supply and protected against being switch on accidently. Take the appropriate automatic circuit
breakers out of the junction box in the building.

Make sure that the foundation is suitable to support the weight of the LED-floodlight permanently and
reliably.

Hold the mounting bracket of the floodlight in the desired assembly position and mark the drill holes.
Use suitable screws to fasten the LED-floodlight. Make sure that no connections are damaged.

Now wire up the connection lines of the building installation at the screw terminals of the light. The
brown (or black) cable is usually the phase conductor. Connect this to the terminal marked with an "L".
The blue conductor must be connected to the terminal marked with an "N".

Do not bend the cable; make sure that the cable and the plug are free from any tractive and torsional
forces. Protect all cables and insulations from any possible damage.

Check the proper connections once again.

Switch on the circuit breakers of the junction box in the building once again
6. Functional faults
The LED-floodlight does not switch on

Is the switch of the LED-floodlight on the wall turned on?

Is the fuse reconnected after assembly?

Has the flap over the PIR sensor been closed?

Has the LUX setting been carefully selected? (see point 8)

Check the connected lines
Heitronic
®
H. Vollmer GmbH
Allmendring 29
D-75203 Königsbach Stein