HeiTel CamDisc VG 2s, Быстрое руководство по установке

Страница: 17 / 28

HeiTel Digital Video GmbH - Quick Installation Guide CamDisc VG 2s
CamDisc VG 2s 17
English
34 pin terminal blo c k
Pin assignment
terminal block
17 1
34 18
Pin
Labelling/
description
Type Function
1 RS-485– Serial (D–) PTZ: Use this terminal to connect up to 10 remote control cameras or
other compatible devices (e.g. matrix) with RS-485/RS-422 interfaces.
2 RS-485+ Serial (D+)
3 Ground PTZ: Common ground for RS-232 interface
4 RS-232 Tx Serial TxD PTZ: Use this terminal to connect 1 remote control camera or one other
compatible device (e.g. matrix) with RS-232 interface.
5 RS-232 Rx Serial RxD
6 Ground Common ground for all inputs of type "control input"
7 Al a/d Control input Arm/Disarm input for enabling/disabling dialup to a CamControl receiver
PC, controlled by "Control in", "Al in", and "Motion Detection" (see
”Wiring variants for voltage-monitored control inputs” on page 19) .
8 V out Control input Control input for manual activation of the HDD safe power down
function
9 Al in Control input Alarm input for dialup with automatic switching of video input 1 (V1 in)
to a CamControl receiver unit (see ”Wiring variants for voltage-
monitored control inputs” on page 19) .
10 Aux in1 Control input Tamper input for dialup with automatic switching of video input 1 (V1 in)
to a CamControl receiver unit.
11
to
12
Control in 1-2 Control input Camera control inputs for external contact triggered recording and/or
selective dialup to a CamControl receiver unit for video inputs 1 to 2 (see
”Wiring variants for voltage-monitored control inputs” on page 19) .
13 NC - Not connected
14 NC - Not connected
15 NC - Not connected
16 Ground Common ground for all inputs of type "control input"
17 Ground Common ground for all inputs of type "control input"
18 12/24V + Power, + Nominal voltage 12 - 24 V DC
The permissible supply voltage is 8 to 30 V DC. Ensure that the supply volt-
age remains within the permitted range in all operating modes.
19 12/24V Power, Ground
20 R1 [Common] Relay Device configuration allows you to allocate the following functions to any
relay:
■
Manual remote control with CamControl LITE , CamControl PRO or
CamControl CLIENT distinguishing between switch and pushbutton
functions
■
Switching to at least one CamControl receiver unit with active online
connection
■
Error relay
21 R1 [normally open] Relay
22 R1 [normally
closed]
Relay
23 R2 [Common] Relay
24 R2 [normally open] Relay
25 R2 [Normally
closed]
Relay
⊥
⊥
⊥
⊥
⊥