4
1.800.221.0932
INSTALLATION
• Attach the panel to the bracket, use the supplied 2.5mm screws.
• The ideal thickness of the mounting surface should be between 1/8” to 1/4”.
• Check to make sure the control wire is long enough to mount the desired location.
• Check the clearance behind the drilling location. Make sure you are not going to drill
through and damage any wiring harness and components in the vehicle.
• Once you decide where to mount, use the bracket to mark the drill location.
• Drill using a 1/8” drill bit, use the supplied pan head coarse screws to attach
• Proceed to Wiring Installation
Switch Panel Mounting
Flush Mount
• There are two different mounting options provided within the HE-SWP8; flush mount (Figure C), and adjustable mount. (Figure D)
(
Figure C
)
(
Figure D
)
*Note:
Do not attempt to extend the control wire. Cutting and splicing may void the warranty and damage the product.
Adjustable Mount
• Attach the panel to the bracket, use the supplied 2.5mm screws.
• The ideal thickness of the mounting surface should be between 1/8” to 1/4”.
• Check to make sure the control wire is long enough to mount the desired location.
• Check the clearance behind the drilling location. Make sure you are not going to drill
through and damage any wiring harness and components in the vehicle.
• Once you decide where to mount, use the bracket to mark the drill location.
• Drill using a 1/8” drill bit, use the supplied pan head coarse screws to attach.
• The supplied Hex key can be used to adjust the viewing angle.
• Proceed to Wiring Installation
