12 Parametrization options
Digital Governor Basic System PANDAROS III
43
12
Parametrization options
The software for the
HEINZMANN
series Pandaros has been designed in a way that will
allow programming both at the
HEINZMANN
factory and by the engine manufacturer.
Since erroneous programming can cause considerable damages, full use should be made of the
level structure and the user masks.
As a principle, first programming should always be conducted by experienced personnel and
must be checked before first commissioning the engine. If possible, a
HEINZMANN
specialist should be consulted when first programming is performed.
The following sections describe the possibilities of parametrizing the control unit:
12.1
Parametrization at the factory
During final inspection at the factory, the functionability of the unit is checked by a test
programme. If the operational data for the control unit is available, the test programme is
carried out using this data. It is then only the dynamics data and if need be the fuel
limitations and sensors that will have to be calibrated on the engine.
12.2
Parametrization with the Hand Held Programmer HP 03
All parametrization can also be done by means of the hand held programmer
‘Programmer 3’. This handy device is particularly suited for development and series
calibration as well as for servicing.
12.3
Parametrization with the PC
Parametrization can also be conducted using a PC and the comfortable
HEINZMANN
software DcDesk 2000. As compared with the hand held programmer, it offers the great
advantage of having various curves graphically represented on the screen and being at the
same time able to introduce changes as well as of having time diagrams displayed without
an oscilloscope when commissioning the control unit on the engine. Furthermore, the PC
offers a better overview as the PC programme has a menu structure and allows to have
several parameters continuously displayed.
Besides, the PC programme permits to save and download the operational data to and from
diskettes.
