CIRCULAR SAW
5. Raise the lower guard (14) by using the lever for lower guard (1)
，
and the remove the saw blade.
6. Clean the saw blade flanges, then mount the new saw blade onto the output spindle and against the
inner flange.
7. Make sure the saw teeth and arrow on the blade are pointing in the same direction as the arrow on the
lower guard.
8. Reinstall the outer flange, and tighten the blade clamp bolt.
9. Make sure that the saw blade runs freely by turning the blade by hand.
Depth adjustment
Loosen the lock lever for depth adjustment (b).
Hold the base plate flat against the edge of the work piece and lift the body of the saw until the blade is at
the right depth determined by the depth of cut scale (4) (align the scale line).
Tighten the depth adjustment lever.
Angle Adjustment
Loosen the Lock knob for angle adjustment (8)
Adjust the shoe to the desired angle between 0 degree to 45 degree. [See miter scale(7)].
Tighten the angle adjustment lock
Switching on and off
Before engaging the ON/OFF switch (16), check that the saw blade is properly fitted and runs smoothly,
the blade clamp bolt is well tightened.
Connect the plug to the power supply
To switch on the circular saw, press the Safety-Lock button (17) and pull the ON/OFF switch trigger (16).
When you release the switch trigger (16), the tool turns off.
Parallel cut adjustment
Loosen the lock knob of edge guide (9).
Slide the parallel guide (11)through the slots in the shoe to the desired width.
Tighten the lock bolt to fit it in the position.
Ensure that the edge guide rests against the wood along its entire length to give a consistent parallel cuts.
Operation
General Cutting
When starting, always hold the saw handle with one hand and the auxiliary handle (5) with the other
hand. Never force the saw but maintain a light and continuous pressure after completing the cut allow the
saw to come to a complete stop. When cutting is interrupted, resume cutting by allowing the blade to
reach full speed and then reentering the cut slowly.
When cutting across the grain, the fibers of the wood have a tendency to lift and tear, moving the saw
slowly minimizes this effect.
Pocket cutting
Disconnect the plug from the power supply before making any adjustments. Set the depth adjustment
based on the thickness of the line drawing for the cut .raise the lower guard by using the lift lever.
With the blade barely above the material to be cut, start the saw and allow the blade to come to full
speed.
Содержание VFC001
Страница 9: ...CIRCULAR SAW...
