7
ROTARY HAMMER
Exchanging and removing drill bits
Fig. A-B
Before exchanging bits, remove the power plug from the wall socket.
Inspect bits regularly during use, Blunt bits should be re-sharpened or replaced.
Lightly oil the bit shaft before inserting it into the chuck.
•
SDS drills can be inserted by pushing the drill into the chuck until a click can be heard. If needed rotate
the SDS drill a little to ensure the keyway in the bit fits the chuck well.
DO NOT slide the locking sleeve (2) to the rear when inserting bits.
•
To remove the SDS drill, slide the locking sleeve (2) to the rear and remove the SDS drill while keeping
the sleeve (2) in the position.
Setting depth stop
Fig. A
•
The depth stop ruler can be added to the side handle by pushing the dept stop button (8).
•
Keep pushing the depth stop button (8) and insert the depth stop ruler (1) through the hole on the side
handle ring.
•
Slide the ruler to the desired depth.
•
Loosen the depth stop button (8).
The On/Off switch
Fig. A
•
Switch the machine on by pressing the On/Off switch (5). When releasing the On/Off switch (5) the
machine will turn off.
•
The rotation speed can be continuously adjusted by pressing the On/Off switch (5) deeper or less deep.
Lock-on button
Fig. A
•
Lock the On/Off switch (5) by pressing the On/Off switch (5) and then pressing the lock-on button (7).
•
Release the switch-lock by shortly pressing the On/Off switch (5) again.
Switching the direction of rotation
Fig. A
•
Direction of rotation counter-clockwise: shift L/R switch (6) to
•
Direction of rotation clockwise: shift L/R switch (6) to
This function is only available when the machine is set to “drill mode “ (as shown in fig D function A&B).
Function selection switch
In order to avoid damage to the machine, adjusting the function selection switch (4) shall
only be done
when machine is not running (Fig .C).
Fig. D
The correct position of the function selection switch (4) for each function is shown in the pictures in fig. D.
Always make sure the function switch clicks in the desired position
A)
Drilling (without hammer function): for drilling in several materials.
B)
Hammer drilling (with hammer function): for drilling in masonry such as brick, concrete and similar
material.
Содержание VCRP002
Страница 2: ...2 ROTARY HAMMER Fig A Fig B Fig C Fig D...
