www.heinner.com 55W, 50Hz, 220V
4
VI. HOW TO ASSEMBLE THE FAN
WARNING: Please unplug the fan before installing to the wall and the grid, and please install the
fan impeller and grid completely (detail as graph) before using.
1.
Attach the stand pipe to the fan base with the attached screws.
2.
Pull out the extension pipe to required height and fasten the pipe locking nut tightly.
3.
Mount the fan head assembly to the fan-stand assembly and fasten the thumb screw.
4.
Remove the blade locking nut and the rear guard locking nut from the motor shaft, attach
the rear guard to the head by tightening the locking nut firmly.
5.
Attach the fan blade to motor shaft and tighten the blade locking nut firmly.
6.
Mount the front guard to rear guard with plastic hoop and tighten the screw on the firmly.
VI. HOW TO OPERATE THE FAN
1.
There is a oscillating knob on fan head. To make the fan head oscillate, simply push down
the clutch knob. To stop the oscillation, pull out the clutch knob. To stop the oscillation,
pull out the clutch knob.
2.
The wind direction can be adjusted upward or downward by simply raising or pressing the
fan head to required tilt angle.
3.
The wind can be chosen by pushing corresponding speed button.
4.
Turn on the timer to preset the running time.
a.
Turn the knob of the timer switch clock wise to set the time, the fan will automatically
stop when the time comes.
b.
Set the timer at position ON, in case the timer switch is not used.
