www.heinner.com 1500W, 50Hz, 230V
16
Cleaning the filter and replacement
The vacuum cleaner has the following filters: HEPA filter; mesh protect cover and post
motor filters.
The filters can become blocked after some time of using and can thereby reduce the
suction power. It is therefore important that the above mentioned filters are replaced
from time to time.
Cleaning or Replacing the HEPA filter
Always unplug the appliance before you replace the filter. Lift out the dust container
from vacuum cleaner.
1. Open the dust container base. Clockwise twister the HEPA hold, depart the HEPA
frame from dust container. See Fig.12;
2. Hold the mesh protect cover and turn clockwise, release the mesh protect cover.
See Fig.13
3. If the HEPA filter is very dirty, rinse it thoroughly with a shower head and use a
brush to clean the dirt on HEPA filter;
4. Then leave the filter to dry (approximative 15 hours at room temperature). You
can only use it again when it is completely dry. If the dirt cannot be removed, insert a
new HEPA filter;
5. Place the HEPA Filter and mesh protect cover back to dust up cover;
6. Place the dust container on the vacuum cleaner. Press the dust container firmly
into its bracket until it audibly clicks into place. Then check if the dust container is
securely seated.
